RED90
OBS Enthusiast
hey guys! I started rebuilding the 700r4 that we have had laying in the garage for quite some time since the one in my truck went out again so....here we go! I purchased the tci maximizer rebuild kit. have yet to buy the torque converter (I am thinking the tork master 2000 from B&M). this is a whole truck build. its getting a new engine too. ill show that in the engines forum. here is some pictures for you. it didn't take more than 2 hours to get it torn down to where it's at.
here is the fluid pan and the valve body. look like there is anything else there...?
well....it has been sitting for quite some time now...that's what a parts washer is for eh? haha
just a peak down inside of the tranny. that's as far as I got before I needed that spring compressor tool...which I didn't have. we did however have the tools to make one!!
as you can see here in the image shown...this is what was fried. completely, and utterly, fried.
here is the fluid pan and the valve body. look like there is anything else there...?
You must be registered for see images attach
well....it has been sitting for quite some time now...that's what a parts washer is for eh? haha
You must be registered for see images attach
You must be registered for see images attach
just a peak down inside of the tranny. that's as far as I got before I needed that spring compressor tool...which I didn't have. we did however have the tools to make one!!
You must be registered for see images attach
as you can see here in the image shown...this is what was fried. completely, and utterly, fried.
You must be registered for see images attach
You must be registered for see images attach