98GooderMadeChevy
Newbie
Man, that floor shifter is sweet. Nice work.My first gmt400 was a 93 Wt. I first bought a $1200 40-20-40 custom seat and installed that in it. It was really to much for that truck, so I sold it to a coworker about 1 year later for $900 plus his old 60-40 seat out of His 94 extended cab. That seat fit the truck much better. I had to drill holes for both swaps. The seat in my 97 extended cab was the 60-40. The drivers side seat bottom fabric was worn. I found a set of bucket seats out of a 95 Tahoe at a swap meet. So that's what I have in my truck now, along with the rear section of a console from a 2004 Tahoe, and the front section that I made with the Chevelle shifter that I also built. I just ordered the shift handle, I built everything else. I could not believe how easy that seat swap was. Only the front hole for the bucket seat on the driver's side did not have a hole for a bolt. Not only did it line up grate, it also plugged into the OE harness and the power seat worked. The 60-40 was not a power seat,but did have the lumbar air bag in the seats.