Disclaimer: Links on this page pointing
to Amazon, eBay and other sites may include affiliate code. If you click them and
make a purchase, we may earn a small commission.
When we did the torque converter all we did was drop the driveshafts, linkage and lines and then slide the trans/tcase back about 4-6 inches. I didn't want to pull the cross member and torsion bars. It only took a couple of hours. It would be plenty of room to do the rear main.
.we will still be able to communicate.. Bonuses and positive feedback are appreciated!if you are not satisfied with my answer,please do not leave bad feed back,i will gladly opt out and let another expert handle the question.i