I built my own "hi four" kit. If your running hi and low beam hids its easy to burn up the stock wires. I bought the heavy duty bulb sockets and built a relay box to pull power right from the battery as hids should.
You must be registered for see images
You must be registered for see images
Top two large posts are for positive and negative from the battery.
Two smaller top posts are hi and low beam signal wires
the posts on the side are for hi beam output and the other side low beam output.
I ran all new wires from each headlight directly to the side posts.
Also ran all four grounds to the top negative post on the relay box.
Installed a diode across the hi to the low beam relay to keep the low beam signal wire from kicking on the hi-beams during low beam use.
I still need to mount the fuse on the bottom but this set up is killer compared to the stock set up. Very easy to build