Search results

  1. T

    No brake or blinker lights

    Had the same problem. No blinkers, hazard’s or brakelights. The Stopfuse was blown. Fixed all but the blinkers. Replaced blinker-relay. Still no blinkers. Maybe multi function switch?! All this happened after a shop welded on my truck without disconnecting my battery Anyone have an idea?
  2. T

    What type of rims are on your truck

    285/70-17 :cool:
  3. T

    How can I adjust the hood?

    Did not work. I pushed the hood down pretty much without any success...
  4. T

    Underhood retractable work light - what fuse?

    Yes, I know because I lost it. Didn`t find it again. But it is really small (short). I think under 1/2 an inch.
  5. T

    Turn signal, hazard lights and brake lights stopped working!

    Battery has occasionally been disconnected for hours. Tomorrow I will try pull codes with a paperclip from the OBD port under the dash.
  6. T

    Turn signal, hazard lights and brake lights stopped working!

    And by the way - how can I cancel the "Service engine soon" lamp?
  7. T

    Turn signal, hazard lights and brake lights stopped working!

    Now it's working! All but turn-signals. Have changed out the blinker-relay (standard electronic relay) and turn-fuse without success. Hazards, brake lights works perfectly and the brake-lamp on the dash is gone. Gone through almost all wiring, grounds and bulb-holders. The stop fuse was blown...
  8. T

    Where does this fuse belong to?

    Turn signal switch has come up a few times. Seems like that could be it. The question is - could welding on a car without disconnecting the battery cause damage to the turn signal switch? They admitted to me they did not disconnect. All lights worked fine when I delivered the car at the shop...
  9. T

    Where does this fuse belong to?

    No fusebox under the hood on the 89. Only under the dash. Have not checked the fusible links under the hood yet though. Don´t know exactly where they go. Would like a wiring diagram. Have been searching on the net.
  10. T

    Where does this fuse belong to?

    No blinkers, hazards or brake lights. Reverse/back-up light working randomly. Happened after a shop welded in a new muffler without disconnecting the battery. Checked fuses, grounds and changed blinkers relay. No clicking. Checked wires going to the rear lights.
  11. T

    Where does this fuse belong to?

    Where on 95+? Replaced engine with a Ramjet 350 crate engine. Maybe it has something to do with that.
  12. T

    Where does this fuse belong to?

    Could be;)
  13. T

    How can I adjust the hood?

    Maybe I could change them out with something nicer :D
  14. T

    How can I adjust the hood?

    Of course I can. This was because norwegian law demanded side blinkers. It's cheap ones and I would prefer it without them.
  15. T

    Where does this fuse belong to?

    Maybe a long shot - maybe someone know? Having some electrical trouble on my 89 Silverado and I found this 5 amp fuse in the glovebox. Have to check all possibilities. It's much smaller than ordinary fuses. Under 1/2 inch.
  16. T

    How can I adjust the hood?

    That was the first thought I had. To use a wooden block. There is actually some 5 mm plastic/rubber shims under the hinge today which could have caused this. Most likely I think the hinge could be the problem, not the hood itself due to the low speed. Will try a couple of 2 x 4 - same problem on...
  17. T

    How can I adjust the hood?

    I thought so - that shims is the way to go. Or maybe replace with new hinges. I have to confess that I drove from home without closing the hood properly. The hood went up, I braked softly - the speed was so low that I thought it did not matter. It obviously was enough. Before this the hood was...
  18. T

    How can I adjust the hood?

    My hood is fine at the front but 1/3 inch too low at the windshield. Can't really see any good way to adjust it?! How do you do it?! Thanks!
  19. T

    Daily truck pics

    Hello from Norway -89 Silverado :)
  20. T

    Underhood retractable work light - what fuse?

    Thanks! Yes, but on my 89-K1500 the reel-lamp is wired directly from the distribution-panel behind the cover on the firewall on the right side in the engine bay. Anyone?
  21. T

    Underhood retractable work light - what fuse?

    There is supposed to be a glass fuse on the wire itself, - which size, anyone?
  22. T

    Turn signal, hazard lights and brake lights stopped working!

    Found this video - didn't look to difficult.
  23. T

    Will 285/70-17 fit

    Yes, no problem whatsoever :)
  24. T

    Turn signal, hazard lights and brake lights stopped working!

    I did check the ground near the rear number yesterday. Looked ok, but cleaned it and used dielectric paste.
  25. T

    Will 285/70-17 fit

    No problem. No rubbing :)

Latest posts

Staff online

Members online

Total: 996 (members: 19, guests: 977)

Forum statistics

Threads
64,476
Messages
1,394,736
Members
51,755
Latest member
GriffisClnCo

Share this page

Top