I hooked up a scan tool today and noticed that, at idle, the TPS percentage wobbles between 0% and 0.4%. I replaced the TPS, with no change. Has anyone else experienced this? I heard someone else say the connector might need to be replaced. What do you all think?
TPS percentage wobbling
- Thread starter _rgk
- Start date
Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
Awest623
A juicy girl got me, again
It's fine. You can reset the zero point if you want it to be steady. There's a few threads about how to do it
Similar threads
Staff online
-
kennythewelderOfficially Retired, B31-3 (6-G) certified welder.
Members online
- Blue91
- Choto
- unknwnzz
- Feedfc
- shablagoo_gabagool
- MarKist
- 99xcss4
- kejty2-Zymcot-vythit
- iDog
- Drunkcanuk
- Road Trip
- jus10inbrla
- Vikingdude
- rhammond
- low99
- Twowheelsqueal
- Idaho83815
- 454C1500
- JPVortex
- Nad_Yvalhosert
- GrimsterGMC
- alabbar
- skylark
- bowtie454
- kennythewelder
- Trio
- Tinman19
- Orpedcrow
- vancecamp
- Supercharged111
- Evan Wyatt
- RAAK
- fancyTBI
- name
- 83GMCK2500
- jgunne