Recent content by Zach Hampton

  1. Zach Hampton

    The Member Truck Thread

    Do 'Lanche mirrors for on the 400s?
  2. Zach Hampton

    The Member Truck Thread

    Might as well add mine here. 99 2 Door Tahoe. 5.7, auto, 4x4. 6" BDS lift. 35x12.50-15 general grabbers. Unknown wheels or wheel specs. Has almost every factory option (I have the original window sticker still). Pioneer double din and full Skar Audio sub, mids, highs. More pics on my IG: hampton_381
  3. Zach Hampton

    What does this go to?

    Never mind! I found it! Sent from my XT1650 using Tapatalk
  4. Zach Hampton

    What does this go to?

    Sorry I should have been specific yes I'm talking about that piece with the spring. Do you know where it attaches? Sent from my XT1650 using Tapatalk
  5. Zach Hampton

    What does this go to?

    I took out my old CB today and found this. Does anyone know what it goes to? Sent from my XT1650 using Tapatalk
  6. Zach Hampton

    Cateye mirrors on a 400?

    I may try to Frankenstein them to make them fit then. I hate the factory 400 mirrors and I don't have a reason to get tow mirrors. Sent from my XT1650 using Tapatalk
  7. Zach Hampton

    Cateye mirrors on a 400?

    My mirrors are shot. My buddy has a 05 avalanche and is getting tow mirrors and is giving me his stock mirrors. I know wiring may not be the same and I can work around that but will they physically fit on a gmt400? Sent from my XT1650 using Tapatalk
  8. Zach Hampton

    LED Cube Retrofit

    I hate bringing up an old thread but has anyone thought of replacing the front running light/turn signals below the headlights with LED bars? Seems like making a plate and mounting them in wouldn't be too hard and you could wire them independently or with high beams. Sent from my XT1254 using...
  9. Zach Hampton

    Engine stumbling above 4k RPM

    No CEL and the grounds are clean and the power is good. It also hesitates for the first 10 seconds or so if you start it after its been warmed up. If you let it sit for 10-15 seconds it's fine but if you immediately drive it feels like you're trying to drag a house behind it. Sent from my...
  10. Zach Hampton

    Engine stumbling above 4k RPM

    My 98 runs great from idle to 4k but once it hits 4,000 rpm it's like half of my engine stops working. It stumbles and pops in the exhaust and has a very large loss of power. Anyone had this problem before? I just did an oil change, cleaned the air filter and MAF sensor and throttle body. Sent...
  11. Zach Hampton

    What should I expect vs my 2012 Tahoe handling?

    I've got all stock with my front bars cranked 1" higher on my tahoe. I'm running 265/75/16 BFG KM2 on sawblades and have the white letters out because I'm 30 and they are still cool to me too. Yesterday I was blazing down a bumpy back road with sweeping turns and short "hills" that really...
  12. Zach Hampton

    k1500 Lower Forged Control Arms

    What is the benefit for using forged I stead of stock? I'm new to gmt400s so I have no clue. Sent from my XT1254 using Tapatalk
  13. Zach Hampton

    305/70r16s stock wheels or buy a set of0s

    I love that style stock wheel on the green hoe. I'm actually looking in my area to find a set. Sent from my XT1254 using Tapatalk
  14. Zach Hampton

    1998 C2500HD

    Don't mind the hard top. I put it on it to sell the Jeep so the top looked like crap because I never used it. It was primered so it didn't match Sent from my XT1254 using Tapatalk
  15. Zach Hampton

    1998 C2500HD

    Sent from my XT1254 using Tapatalk
See more

Latest posts

Staff online

Members online

Total: 1,038 (members: 21, guests: 1,017)

Forum statistics

Threads
64,464
Messages
1,394,644
Members
51,727
Latest member
Bams79k20

Share this page

Top