Recent content by Sleeper Van

  1. S

    Low voltage

    First off I would disconnect the battery and bring it up to a full charge slowly! Then do a test on it to see if it draws down quickly. If you don't have a load tester then bring it to Auto Zone fully charged and ask them to check it for you. They do this free of charge so it's worth the...
  2. S

    valve adjustment

    I've found that the best way to adjust the lifters is to do a basic by the book starting point. Then I do the final adjustment with the vechiel running. Yes I said running and I'll explain why: First off your going to need the clips that snap on to the rockers that keeps the oil from squirting...
  3. S

    Delco starter

    If you need a new/different heat shield Amazon has one for around $20.00. it's a double folded piece that has good heat resistance and it bolts up to the solenoid. Just FYI in case you need one. Good luck.
  4. S

    Aftermarket Radio help?

    I wanted to add that if everything that was giving you problems goes away after you disconnect the head unit then you know that it's in that unit. If everything is still not working check everything in the area of the Radio and look for a loose wire or a plug that is loose. Did you add any new...
  5. S

    Aftermarket Radio help?

    It sounds like a bad ground and a crossed wire. Just because the colors matched up doesn't mean that they go together. I had a similar situation with a Buick. It turned out to need an additional ground and the wire for the dash lights was different than the wiring instructions. I'd start...
  6. S

    Anyone tune TBI anymore??

    First off I wouldn't use the Holly throttle body. The stock TBI is capable of handling just about anything you can throw at it. If this is a 350 motor it's more than enough to handle the power. You can add bigger injectors, increase the fuel pressure and so on. Your going to need a different...
  7. S

    r12 to r134a and new AC compressor

    Four Seasons is a very good product and has been around for as long as I can remember. As far as the Conversion goes don't forget that you have to completely flush the system and replace all seals and gasket's. The reason for this is the 134A uses pag oil. Make sure that the shop you go to...
See more

Latest posts

Staff online

Members online

... and 15 more.
Total: 1,939 (members: 65, guests: 1,874)

Forum statistics

Threads
64,673
Messages
1,398,538
Members
52,210
Latest member
toylman

Share this page

Top