Also, make sure your pinion angles are correct before diving in fully to the rear. Those step rails are good but after doing that much work, wouldn't it be badass to retrofit some new chevy fold up's to the truck? This is one of the most invasive builds I've ever seen and you deserve to spend...
I've had automatics do this too. In my 2000 my shift solenoid was going bad and would cause rough or no shift conditions. My friends g35 also did that at 45mph. Id double check your trans grounding points, fluid level in trans, and driveshaft/bell housing/tranny mount alignment.
Do you have a...
"Fast and mean v6" needs everything done to it.
I'm pretty sure there's a few of those sitting on my friends land, are they actually worth anything in the right condition? No rust in central TX (usually).
I asked because of your fab skills, seems like you do it for a living because you're good at it.
Nice boat! I am reserved to bank fishing for now but some day I'd like one just like that, except a shallow bass boat may be more practical around here.
Not exactly the right thread for this, but it definately catches my eye! (The car and the paint!) It is a chevy after all...
The effect on the paint is stunning. He also talks about it a bit more in depth at about 2:30. Check it out!
In the truck! Anybody got any good ideas for speaker grills? Didn't think I'd need them, but kid feet never stop moving so I could use a set!
I think mid range is next!
Unfortunately the box got a bit of water damage and started to swell the paint on one corner, might be time for a redesign!