Recent content by rideitall
-
R
Frying ICM's
Very similar setup (Accel coil, Super Stock wires, etc...) and experience save the TBI. A very good friend is a service manager at a dealer and got to talk to one of his mechanics. He's of the opinion it's the coil frying them, swapped stock ignition components for all Accel, including ICM, last...- rideitall
- Post #6
- Forum: Engine Performance + Maintenance
-
R
Frying ICM's
yeah. using the dialectric supplied with the icm.- rideitall
- Post #3
- Forum: Engine Performance + Maintenance
-
R
Frying ICM's
Last year I replaced my ignition coil and ICM on my '95 1500 (V6 TBI) 'cause I don't drive it too often and they were looking ragged. Now I'm frying ICM's. I am literally getting about 10-15 miles before they go out. Been through 3 already. Anyone have any experience with this. It's been...- rideitall
- Thread
- Replies: 7
- Forum: Engine Performance + Maintenance
-
R
Axle swap
It's claimed to be from a 92 GMC 1500 GU4 option w/discs and should bolt up fine but I'm not sure about the changing over to discs (If it does in fact have disc, I haven't seen it yet). Would like to keep 'em if it's do-able.- rideitall
- Post #3
- Forum: Axles + Brakes
-
R
Axle swap
I have a 95 C1500, 4.3 V6, with the GU6 3.42 rear end ratio w/ drum brakes. I have an opportunity to get a 3.08 GU4 (I want the 3.08 since I don't tow and prefer the better mileage that should result) w/ disc brakes. Question: While I know the axle will bolt up, what changes will need to be...- rideitall
- Thread
- Replies: 5
- Forum: Axles + Brakes
