Recent content by Randyb2004

R
Anybody see this before??

For one axle tube to turn like that without the other side moving it had to have broken the welds to the center section on one side. Not necessarily the side that turned.
- Randyb2004
- Post #107
- Sep 21, 2021
- Forum: Axles + Brakes
R
Glovebox won’t shut unless slammed

For a 1995: First I welded up my latch to make it about 3/32" longer, then it no longer fits in the hook. Then I filed the inside bigger by the same amount I added on the outside ( about 3/32") seems to work much better now. You could just cut the sides and extend it too ( 3/32" + the width of...
- Randyb2004
- Post #17
- Aug 20, 2021
- Forum: OEM and Custom Interiors
R
Need Help Badly

Step one, plug in a scan tool. Look at engine and air temp both cold and warm. Are sensors working? Next look at O2 sensor readings, .1 to .9 volts and moving around alot. When it starts to die, put a short shot of carb cleaner or starting fluid into the throttle body, if it dies or gets...
- Randyb2004
- Post #28
- Nov 12, 2018
- Forum: Engine Performance + Maintenance
R
Restricting IAC passages

I would be looking for a gasket mis-match or other vacuum leak. Air is getting in somewhere, I doubt you will need to restrict the passages. Any leak in the intake, brake booster, or other hose will give you the problem you are having. The IAC is the restriction. It's a needle valve (more...
- Randyb2004
- Post #20
- Nov 27, 2017
- Forum: Engine Performance + Maintenance