Recent content by norton
-
N
Upgrade steering parts
sent an @mail to Lares support for have some info about torque value and rubber disk distorsion problem.. this was the reply: "The torque specs are correct. With that said if the disk is a little compressed that's ok, however the only time I have ever run into this issue before is when the...- norton
- Post #87
- Forum: Stock Suspension + Bolt On Kits
-
N
Upgrade steering parts
for now installed a Lares 205 coupling rag joint replacement, not bad at all, but the rubber disk can be pinched/compressed much when install at Lares torque value of 11 lbs/ft, so pay attention when you torque the 2 bolts on RAG joint. a little compression on the rubber disk is needed but not...- norton
- Post #78
- Forum: Stock Suspension + Bolt On Kits
-
N
Upgrade steering parts
nobody used C3500 GM 26015779 steering shaft for 96+ models? ... for what i can see it has a GM coupling for steering box (safe and strong), U-joint then goes to an 1"DD shaft and a 3/4"DD insert for upper part... i wouldn't use the intere part, used the lower with u-joint and put the 3/4"DD...- norton
- Post #75
- Forum: Stock Suspension + Bolt On Kits
-
N
XJ Steering Shaft Upgrade (88-94 Trucks) 95+instructions on page 31
someone used C3500 GM 26015779 steering shaft for 96+ models? ... for what i can see it has a GM coupling for steering box (safe and strong), U-joint then goes to an 1"DD shaft and a 3/4"DD insert for upper part... i wouldn't use the intere part, used the lower with u-joint and put the 3/4"DD...- norton
- Post #553
- Forum: Stock Suspension + Bolt On Kits
