Recent content by Nobodys94

  1. Nobodys94

    Nobodys94 Daily driver (slow project)..

    I had to ditch the 1/4 spacers up front when i lowerd the truck more. To gt the center caps to fit I took my dremel and beveled the sharp ridge innside the center cap to fit over that lip on the rotor. I have tried to polish the whe3ls with several different good wheel polishes. None have...
  2. Nobodys94

    Nobodys94 Daily driver (slow project)..

    My rear shackles are only in the 1 inch drop holes. Gonna move them down to the 2 inch drop slots this weekend when i do a super c notch
  3. Nobodys94

    Nobodys94 Daily driver (slow project)..

    Dble post
  4. Nobodys94

    Nobodys94 Daily driver (slow project)..

    Got the rear tires on today. Then told the guy too order me new front tires and he says they dont make the 255/45/20 in the toyo proxes st anymore. So i gotta go with a wider or taller or both in the front if i want the tread pattern to match. Which i do. I am just picky that way. So the...
  5. Nobodys94

    Nobodys94 Daily driver (slow project)..

    finally some progress Install 31 bar Grill. Check. Next, Build turbo 5.3 ls. Engine is down to short block. It's gettin refreshed now. I still got to port the heads and get cam n springs. I have already modified the ls harness. Took a whole rigging day but it's done. Before the...
  6. Nobodys94

    5.3 Into my 94?

    The wiring seems a bit intimidating. But once u have crammed a Viper V10 into a 95 Mustang, an LS swap in these trucks seems like childs play. LOL
  7. Nobodys94

    5.3 Into my 94?

    After figuring all the cash I would spend on rebuilding my 350 I reverted back to my original plan for a turbo LS motor plan. So just bought a running 5.3 with harness and all from LKQ for $296.. There is a sticky at LS1truck on the how to swap for the OBS. I Have been over a dozen times the...
  8. Nobodys94

    Engine Stuttering during acceleration

    U need to check the TPS and also all the other sensors while your at it. Get a multimeter if you dont have one and follow Yeti Owners posts on how to check all the different sensors. Its all very simple and will take less then an hour. Best thing u can do at this point.IMO.
  9. Nobodys94

    Did TBI mods and spacer today. Now truck dies upon accel from idle. please help?

    I just looked at my friends 93 tbi and he has done the tbi mods as well. He has INJ pod spacer and 2 gaskets, But his injectors spray a nice cone pattern and has no splatter. Looks much more uniform type spray then mine. Guess I need to get fpr gauge and start there. I know my vid suks, but Its...
  10. Nobodys94

    Did TBI mods and spacer today. Now truck dies upon accel from idle. please help?

    Truck had a tiny bit of that hesitation earlier when I drove it. I have No codes and its going to closed loop when warm. It does take the truck a long time to warm up. Its still staying between 160 and 170.. But does go up to 200 in traffic and drop to 160 when t-stat opens. When going down the...
  11. Nobodys94

    new alternator will it help

    I got my fans off an Olds intrique. I have a 130 amp alt and it drops from 14.4 to 13.2 with fans , stereo system and HID'S going all at once. The best thing u can do now is the the planned upgrade of the bigger wire. I havent done that yet either. My truck never got above 140 cause the clutch...
  12. Nobodys94

    bosch reman injectors anyone ever use them??

    Never mind my original post, it seems very few L29's had single pintle INJ. Are yours leaking around the body?
  13. Nobodys94

    Did TBI mods and spacer today. Now truck dies upon accel from idle. please help?

    Going to do the jumper today and see what I get.. Just replaced o2 when I did the headers, egr seems to be working now. I have new Delco R44ts plugs, cap, rotor and wires sitting in the shed. Also got an MSD coil for it. Gonna do it all Saturday. I try to keep my tires at 42 psi, but I dont...
  14. Nobodys94

    Did TBI mods and spacer today. Now truck dies upon accel from idle. please help?

    I am getting 10mpg around town. Driving normal keeping my foot out of it.. Highway I got 14mpg on a 350 mile trip I took a few weeks ago. All these mods was me hunting better mpg.. After all the videos I watched earlier showing the TBI injectors spray pattern. Mine look nothing like those in...
  15. Nobodys94

    Did TBI mods and spacer today. Now truck dies upon accel from idle. please help?

    Yeah thanks again. So what ya think about the injectors splatter fuel everywhere and they are dripping too? Probably coulda got away with the height of the gaskets and pod spacer if they werent so outta wack.
See more

Latest posts

Members online

... and 44 more.
Total: 1,395 (members: 94, guests: 1,301)

Forum statistics

Threads
64,762
Messages
1,400,114
Members
52,391
Latest member
chrisidkk

Share this page

Top