Recent content by Montyhaulz
-
Lets's talk Corrosion, a.k.a. Rust!
Northeast states seem to be worst.I know down by Cape Cod or near oceans can be real bad as I almost bought one from CC and cause of salt water was unusable. I have been able to poke fingers through some frames easily as I looked at them. When I look for a truck for parts I take a body pick...- Montyhaulz
- Post #2
- Forum: Stock Suspension + Bolt On Kits
-
Hello from mass.
So if I keep my 350tbi, th350,transfercase. Would a 700r4 bolt up to stock transfer case? I understand new driveshafts may be needed as 700r4 is roughly six inches longer than current setup. Which would require moving TC crossmember back as well.- Montyhaulz
- Post #12
- Forum: Introduction
-
1990 GMC K1500 restoration
What an amazing job I am following!- Montyhaulz
- Post #52
- Forum: Member Trucks
-
-
-
Hello from mass.
I found a place In Maine that sells 4 wire stand alone LS motors and just need to cobble together correct pieces to make it all work.- Montyhaulz
- Post #5
- Forum: Introduction
-
Hello from mass.
Yes I have a 350 tbi turbo 350 trans. and would like to do 5.3 to OD just not sure if transfer case current would work?- Montyhaulz
- Post #4
- Forum: Introduction
-
Hello from mass.
- Montyhaulz
- Post #2
- Forum: Introduction
-
Hello from mass.
89 k2500 no OD to 5.3 w/ OD but which TFcase??- Montyhaulz
- Thread
- Replies: 13
- Forum: Introduction
