Recent content by MNZ71

  1. MNZ71

    Post your white 400's

    Day I bought it What it looks like now Sent from my iPhone using Tapatalk
  2. MNZ71

    K1500 on 15x8 rally wheels

    The tires stick out a couple inches on these rims. The rim itself is probably about even with the truck
  3. MNZ71

    K1500 on 15x8 rally wheels

    They stick out about an inch past my flares so they would be roughly 2 inches without flares. That's with 33/12.5 mud terrains.
  4. MNZ71

    K1500 on 15x8 rally wheels

    Doesn't show the wheels real well. I can get get a better pic tomorrow if you want.
  5. MNZ71

    Putting A Chip In A TBI Truck

    I have a jet stage 2 that the po installed. Ive had the truck for almost 30000 miles and always run regular fuel with no ill effects.
  6. MNZ71

    Installing new blend door actuator...Any special things to know?

    The door and the motor are keyed so it can only go on one way. You really cant mess it up.
  7. MNZ71

    2 inch blocks with a crank and 33s?

    2" block and crank to level
  8. MNZ71

    Small black box on frame?

    The pic you posted is a back up alarm so that's what I'd guess is in your truck.
  9. MNZ71

    NO truck yet - NJ

    This ^^^ It may have been made in late 95 but its a 96 model year.
  10. MNZ71

    NO truck yet - NJ

    All 95's were obd1. They switched to obd2 in 96 when they went to the vortech engine.
  11. MNZ71

    Lets see those tools and toolboxes

    I have a Snapon box. Mostly Snapon tools with some Matco in there as well.
  12. MNZ71

    Speaker Write Up

    Ill try to get a pic of my 6x9s in my extended cab tomorrow
  13. MNZ71

    axle shims needed after 2" lift using blocks and crank???

    The shaft should be no more than 3 degrees and both angles should be within 1 degree of each other
  14. MNZ71

    axle shims needed after 2" lift using blocks and crank???

    I have 2 inch non angled blocks on mine. I had the same question about shims so I actually measured my angles and they were still within spec with my 2 inch block without any shims.
Top