Recent content by Kitsune474

  1. K

    Cruise Control issues

    I will definitely have to try that. (sounds like the cheapest and easiest so I just gotta start there)
  2. K

    Cruise Control issues

    98 Chevy K1500 About a year ago now I replaced a few things including my brake lights/turn signals/reverse lights to LED and doing a brake job all around. I've heard things about the LED's causing issues with cruise control and turning on the ABS light which I have both going on. I just want to...
  3. K

    No turn signal/brake light

    Well after putting it off until I got pulled over for it one night I finally dove into the multifunction switch and realized it was completely my mistake. I was having a lot of issues with the passlock system (fixed by getting a new ECU) but at the time I was told I should try grounding a yellow...
  4. K

    No turn signal/brake light

    I'll have to get in there with the 12v test light and see if there's any power leaving the switch
  5. K

    No turn signal/brake light

    Rear passenger side is working and both sides on the front are working. I actually replaced the multifunction switch last fall in a hope to fix my cruise control (to no avail). I didn't have enough daylight today to poke around under the dash with the tester, but I imagine the issue has to be...
  6. K

    No turn signal/brake light

    Haven't wired it in yet because of the issues I ran into
  7. K

    No turn signal/brake light

    ***UPDATE*** So I've made sure all the wires in the tail light harness have continuity, I assumed maybe a wire had been pinched somewhere along the frame. I disconnected the plug under the brake master cylinder and decided to check the male end that goes into the cab and alas no power for left...
  8. K

    No turn signal/brake light

    98 K1500 here I bought a new cap for my truck and when I went to wire it in for the 3rd brake light I found that my drivers side brake light and turn signal wasn't working. The truck used to have a trailer light plug in the bumper before I removed it so there are a lot of extra wires going on...
Top