-
-
HHyp3rDeath101 replied to the thread Anybody know of a cheap speedometer that works good? Also, has anyone done an older dash swap?.Tried wiring the speedo straight to the VSS on the transmission. The pulses per mile for the sensor is at 100k. Calibrated my AutoMeter...
-
HHyp3rDeath101 replied to the thread Need some noisy car prank ideas.You just gave me some of the best ideas! Might have to try them all soon... :rotflmao:
-
HHyp3rDeath101 replied to the thread Anybody know of a cheap speedometer that works good? Also, has anyone done an older dash swap?.Finally got another go with the scanner (friend of mine has one), and he kept an eye on the MPH as I drove around. MPH was perfectly...
-
HI have a 1994 Extended Cab Silverado that I recently replaced the gauges in with AutoMeter gauges. All other gauges work perfectly...
-
HHyp3rDeath101 replied to the thread Anybody know of a cheap speedometer that works good? Also, has anyone done an older dash swap?.Confirmed that the speedo starts getting erratic doing acceleration in frosty mornings, and the engine won't go when given decent...
-
HHyp3rDeath101 replied to the thread Anybody know of a cheap speedometer that works good? Also, has anyone done an older dash swap?.Had a spare VSS buffer, and zero change. It was also frosty this morning, and the speedo was going absolutely haywire. It was constantly...
-
HHyp3rDeath101 replied to the thread Anybody know of a cheap speedometer that works good? Also, has anyone done an older dash swap?.New gauges from AutoMeter are installed and working! However, even after all the wiring is fixed up properly (no T-taps :headbang: ), my...
-
-
HHyp3rDeath101 replied to the thread Engine dies for 2 seconds after pressing throttle, and then suddenly goes.My cylinder heads have the number 193 as the last three digits, which I believe would be the stock ones... Maybe they were replaced at...
-
HHyp3rDeath101 replied to the thread Engine dies for 2 seconds after pressing throttle, and then suddenly goes.My engine is stock, and yet the cylinder heads don't have the EGR exhaust port, but my intake does... No exhaust gas for EGR
-
HHyp3rDeath101 replied to the thread Engine dies for 2 seconds after pressing throttle, and then suddenly goes.Tried checking fuel pressure, but the test fitting refused to thread in, so couldn't really test that. However, I was able to finally...
-
HHyp3rDeath101 replied to the thread Engine dies for 2 seconds after pressing throttle, and then suddenly goes.Unplugged EGR NOT the problem! I did have a code for the Map Sensor, so maybe that is the problem?
-
HHyp3rDeath101 replied to the thread Engine dies for 2 seconds after pressing throttle, and then suddenly goes.Apparently the EGR solenoid was unplugged the ENTIRE time! And I was wondering why the engine was having problems. :doh2: Should run A...
-
HHyp3rDeath101 replied to the thread Engine dies for 2 seconds after pressing throttle, and then suddenly goes.EGR system has been fully disconnected from the vacuum system and plugged off. No change had occurred as a result. I'll be able to use a...
-
HHyp3rDeath101 replied to the thread Engine dies for 2 seconds after pressing throttle, and then suddenly goes.Turns out that the TPS didn't do much to the problem. The EGR on my engine is the original, so it's probably dead after 30 years of 200...
-
HHyp3rDeath101 replied to the thread Engine dies for 2 seconds after pressing throttle, and then suddenly goes.Had a spare throttle position sensor for the TBI, as I'm rebuilding a junk one in case the current one dies. Decided to install it and...
-
-
Loading…
-
Loading…
