Recent content by hiredgun8

Freshly rebuilt 350 not starting!

With that much "bounce" in them....I'd be surprised if your valves open far enough if at all.
- hiredgun8
- Post #62
- Oct 9, 2015
- Forum: Engine Performance + Maintenance
Best Wiper Blades?

I put these on 3 weeks ago and love em. Better than the ANCO and Rain-X I used to use.
- hiredgun8
- Post #23
- Oct 9, 2015
- Forum: Paint / Body / Detailing
Heavy Duty Headlight Harness and 4 Hi

That diode will not do it. That one limits you to 12v. The first time you start your truck it will blow it. Look for a diode in the 8-10 amp range and 50V or higher. I use T10A40L's. And remember current flows toward the stripe. And soldering them in is always better than any crimp connector.
- hiredgun8
- Post #68
- Oct 9, 2015
- Forum: Wiring Diagrams
Cheapest Battery for K1500 5.7L

On my 5th NAPA in 2 years. Used to be good quality batter but I'd say not anymore.
- hiredgun8
- Post #13
- Aug 20, 2015
- Forum: Audio + Electronics
Bolt, nut storage

Mason jars. Screw the lids to the bottom of the work bench or shelf and screw the jars into them. Easy to see what you've got.
- hiredgun8
- Post #10
- Jul 21, 2015
- Forum: The Garage
going to pick up an old truck

A trailer. :)
- hiredgun8
- Post #4
- Feb 21, 2015
- Forum: Engine Performance + Maintenance
Just joined‼️

Welcome from Clarksville
- hiredgun8
- Post #6
- Jan 26, 2015
- Forum: Introduction
Coolent temp sensor for temp gauge. The one on drivers side between #1 and #3 Cyl's

Mine was reading low (120 deg) I changed my temp sender out with this one from NAPA and now it is right on with the ECM temp.
- hiredgun8
- Post #3
- Jan 12, 2015
- Forum: Engine Performance + Maintenance
New in Tenn.

Welcome from Clarksville
- hiredgun8
- Post #6
- Jan 4, 2015
- Forum: Introduction
Engine Compartment light

Mercury or ball bearing. Either way you can bend it just slightly to make t work right.
- hiredgun8
- Post #7
- Dec 23, 2014
- Forum: Engine Performance + Maintenance
CD divider/cup holder

Ebay Link
- hiredgun8
- Post #8
- Dec 21, 2014
- Forum: OEM and Custom Interiors
The Stupid Electronics Questions Thread

That's a crossover for separate highs and lows.
- hiredgun8
- Post #272
- Oct 14, 2014
- Forum: Audio + Electronics
Lets see those tools and toolboxes

Looks like a nipper or end cutter.
- hiredgun8
- Post #117
- Oct 5, 2014
- Forum: The Garage
Newbie in Illinois

Welcome
- hiredgun8
- Post #14
- Sep 24, 2014
- Forum: Introduction
Mode Door

I replaced both at the same time. Like I said if you pull the bottom cover off your air box....you'll have more room to work.
- hiredgun8
- Post #8
- Sep 1, 2014
- Forum: OEM and Custom Interiors