So, I'm having a debate with myself about replacing my upper and lower ball joints. I've been reading a lot of info on Mevotech and just wanted to get some feedback as to whether I should go that route. Has anyone used that brand and if so, what are your opinions? Mainly, I'm considering the TTX...
Update on my truck and it's overheating issue. I took off all of the hoses for the cooling system and found that they were all caked up on the inside with rust and decided to play it safe and replace them all. I've only got a few more left to replace before I refill it with coolant in hopes that...
I made sure to put the new one in tthe same way the old one came out. I'm no master mechanic or anything. I worked at a mechanic shop and would ask my coworkers about what I should do to go about fixing my issues.
The upper hose felt luke warm. I have my truck parked on level ground and I planned to use a Lisle funnel but none of the adapters would fit for some odd reason so I did it by having my wife watch the gauge while I kept coolant going in and up to the level where the cap goes on. I did make sure...
Back when I first got the truck 3 years ago I had no clue that the guy had only ran water in it. The water that came out when I put the new radiator in was rust colored. I also noticed what looked like someone tried using JB Weld to patch a leak at some point. The upper radiator hose was mildly...
About a month ago I noticed my truck running a little warmer than it normally did. At first I didn't think anything of it until it happened again especially with my temp gauge not reading properly due to needing the sending unit replaced. Recently I replace both the sending unit and the temp...