Recent content by Bradenchu
-
Exhaust tips.
Everyone has round tips, figured il build a set of hexagon ones. There 4 inch tip to tip. Sent from my iPhone using Tapatalk -
Antifreeze Pouring Out
Pulled my fan shroud off and pressure tested it this evening, turns out the plastic along side of the rad is cracked and antifreeze is seeping out of it. Guess its time for a new one!- Bradenchu
- Post #7
- Forum: Engine Performance + Maintenance
-
Antifreeze Pouring Out
The temp sensor crossed my mind, not 100% on the freeze plug id have to check but im sure its good, rad leaking under pressure could be another possibility but wouldn't it drain the rad and holding tank with it? same goes for the intake gasket id have to look at that to. Standing beside the...- Bradenchu
- Post #4
- Forum: Engine Performance + Maintenance
-
Antifreeze Pouring Out
The other day I noticed my reservoir was low on coolant, so I filled it up and never thought much of it. This afternoon I noticed a little puddle on the ground and after I drove it home 15 minutes when I parked and shut the truck off there was coolant pouring out off the frame. The Frame a-arms...- Bradenchu
- Thread
- Replies: 7
- Forum: Engine Performance + Maintenance
-
Another Canadian
Nice to see another truck from Swan Valley on here!- Bradenchu
- Post #21
- Forum: Introduction
-
What is the best aftermarket part you have put on your truck?!
Definitely the exhaust, She roars!- Bradenchu
- Post #26
- Forum: Stock Suspension + Bolt On Kits
-
anyone running a led tailgate light bar?
Those are them. The wires are just spliced into the normal brake light harness. The strips could have been longer but it was all they had at the time- Bradenchu
- Post #7
- Forum: Audio + Electronics
-
anyone running a led tailgate light bar?
I will take some and upload them later on- Bradenchu
- Post #5
- Forum: Audio + Electronics
-
anyone running a led tailgate light bar?
All i use is 2 12" red led strips that i picked up from wal-mart, wired them into the brake and signal lights. Been working good ever since- Bradenchu
- Post #2
- Forum: Audio + Electronics
-
-
Tire size question
How do you determine what the best gears would be to put in- Bradenchu
- Post #7
- Forum: Stock Suspension + Bolt On Kits
Members online
- hammer211510
- Zd92
- KMo_00
- Erik the Awful
- msmall
- 99xcss4
- Zadaminsane
- Griffin
- Prokiton
- bhack3311014
- OBSsesed
- Tomcat71
- PolarBear
- 95OBSMan
- StickySteve88
- mars2878
- Caman96
- deadweight
- modernbeat
- supspt454
- Jskingry
- Macs Garage
- joem38
- Wolfpackfan21
- vince72
- Nad_Yvalhosert
- El Tigre
- Green1998
- goldtop
- fancyTBI
- RichMoss
- Martin Evans
- WhiteUCF
- deanob22
- Art Molina
- Ckeene
- jaywestfall
- pap-repair
- Andrew_M_14
- Tahoez71
- rray670
- BradB
- Road Trip
- SNCTMPL
- caw_86
- Willpowr101
- Garyg
- Cv100902
- HectorZero91
- Dunkin916