Recent content by axisT6

  1. A

    OBS rear axle width

    From my experience, the 88-98 truck/suv 5 lug 10 bolts are all the same.
  2. A

    OBS rear axle width

    This is not accurate. Here is a killer swap with factory parts: 1. Locate a 2000-2007 Disc Braked 8 lug 14SF. 2. Order shafts for a 88-98 Z71. 3. Order rear brake rotors for an early 2000s 3/4 ton 6 lug Van. This his will get you a 6 lug 14SF with larger 3/4 ton discs and parking brake...
  3. A

    7.4 Vortec k2500 Exhaust Manifold/ Header Install

    Confirming, the down pipe pieces with the 3 bolt flanges came with the headers?
  4. A

    1995 c3500 lift

    Thread dig/resurrection. Serious tech here. Sent a DM.
  5. A

    Body Mount Question

    In the process of installing Poly body mounts. The large metal washers that go on the bottom of the mount have stamped numbers as follows: A5, B5, A4, etc.... Can anyone tell me which one goes where? I didn't pay attention when I removed them. My truck is a 95 ECSB for reference.
  6. A

    5 or 6 speed auto transmission Conversion?

    Another vote here for torque converter. Assuming your 35s measure closer to 33s, your rpm at 80 should be about 2340.
  7. A

    SAS with long tube headers? Anyone?!

    I don't have a picture, but will be fabricating mine shortly. For my truck, I have to set the bottom of the shackle hanger to be flush with the bottom of the chassis as the header collector will be right above it. Since the Z71 chassis is taller than the 2wd chassis, the hanger will not...
  8. A

    SAS with long tube headers? Anyone?!

    Return the shorties if you can. You can clear long tubes, you just need custom rear brackets. My truck SAS'ed and I will be installing LTs. Can you fab? Do you have access to anyone who can fab?
  9. A

    14 Bolt SF Build

    Need to thin the gear paint some more, but the 0.036" - 0.038" look good.
  10. A

    14 Bolt SF Build

    Big Blue, read this: http://www.ringpinion.com/Content/HowTo/TechnicalInstructions/Yukon_Installation_Kit_Instructions.pdf It also has torque specs.
  11. A

    14 Bolt SF Build

    The shims are behind the inner pinion bearing.
  12. A

    14 Bolt SF Build

    Any time. I just didn't want you to have to take everything apart after getting the axle installed and driving on it. Rule of thumb with crush sleeves is to carefully tighten the NEW pinion nut until there is no longer any axial play in the pinion i.e. the pinion bearings are seated in the...
  13. A

    14 Bolt SF Build

    Good lookin' pattern man.
  14. A

    Let's talk lockers

    Notice that I didn't quote the OP. My thought is, if you are going to drop $$ on an ARB, at least have something better than a 10 bolt. Of course, this my opinion.
  15. A

    Let's talk lockers

    I hope you are not ARB'ing a 10 bolt.....
See more

Latest posts

Members online

Total: 826 (members: 27, guests: 799)

Forum statistics

Threads
64,706
Messages
1,399,175
Members
52,278
Latest member
Mocky

Share this page

Top