Recent content by 7Brandon07

  1. 7Brandon07

    Ignition timing?

    I though about that, I did set up a camera on the injectors it does spray fuel if I try to start it, however if I just turn the ignition on and move the throttle on the tbi it does not spray fuel I don’t know if that’s normal ? But if I actually turn it over it does
  2. 7Brandon07

    Ignition timing?

    Hey guys I have a 91 with a 305 anyways my oil pressure sensor was leaking oil my truck drove just fine to the auto parts store to get the new sensor n just fine to get back home I proceeded to remove the distributor to get the oil pressure sensor out much easier I got it out new one in, when...
  3. 7Brandon07

    Nv3500 swap

    I bet you can make it work, May have a little modifying involved but there’s going be a little modifying involved going from auto to standard regardless. Bellhousing may be a little different
  4. 7Brandon07

    Looking to Manual swap my '91 k1500

    TKO 6 speed for perfomance For stock Nv3500 easiest swap if get donor
  5. 7Brandon07

    1991 transmission problem

    Hey So I have got a 91 Silverado 2wd 5 speed manual transmission got a leak took a peek noticed a hole, my question is is this hole there because it’s damaged or is this hole there because something is missing if something is missing what is ? thanks for any help
  6. 7Brandon07

    (!)(P)BRAKE light staying on all the time.

    I had a car once that had a sensor on the parking brake lever much like the sensor for the brake pedal don’t know if these trucks are like that probably not.
  7. 7Brandon07

    Oil pressure gauge

    Hey, so I got a 91 gmt400 I got the gauges that are the other style that does not have needles not sure what there called but anyhow my oil pressure gauge reads 30 when it’s not running and 30 when it is running it never changes from 30 ever, I’d like to fix this, could it be likely to be the...
  8. 7Brandon07

    Identifying transmission

    From what I’ve been reading I’m assuming it’s the 5lm60, well now i know not to bother getting this one rebuilt, my plans are to either rebuild the 305 or get a rebuilt 350 one day do the same with the trans but seems it’s much better to get a different trans when this all happens, what’s a good...
  9. 7Brandon07

    Identifying transmission

    Which digit is the transmission rpo code anyone know ? I noticed most of them start with a M I only have two pro codes that do mg5 or mm5 mg5 is a top code for a getrag 5 speed I know m50 is a nv3500 not sure if I’m looking at the right digits in my sheet
  10. 7Brandon07

    Identifying transmission

    Damn hopefully I got the nv3500 I read somewhere they started using it in 93 though and I have a 91 but I also read elsewhere they started using in 88 so not sure
  11. 7Brandon07

    Identifying transmission

    Is the nv3500 the same as the hm290?
  12. 7Brandon07

    Identifying transmission

    I got a 91 5 speed standard I understand they used a few standards on these trucks wandering what mine might be the bell housing is integral to the unit and it has a waffle design Thanks
  13. 7Brandon07

    Cost For Alignment

    Its varies between 49$-75$ in the cities I’ve lived in
  14. 7Brandon07

    Need some advice after blowing a tranny

    Did you change the oil in the tcase?
  15. 7Brandon07

    Need some advice after blowing a tranny

    Bad seals or bearing I’ve never seen a rebuilt tcase or transmission leak fluid unless the seals weren’t properly installed, I worked at a transmission shop doing RnR never learned much about rebuilding them or how they work but I pulled out many a bad trans and put in them once they were rebuilt.
See more

Latest posts

Staff online

Members online

Total: 1,036 (members: 24, guests: 1,012)

Forum statistics

Threads
64,382
Messages
1,392,650
Members
51,525
Latest member
Cptfordo66

Share this page

Top