lucky67bsa
Newbie
- Joined
- May 13, 2015
- Messages
- 15
- Reaction score
- 3
I had to swap the transfer case out of my truck for a different one. I am not able to use my original drive shaft for the front because the yoke is different. My original yoke is the flat flange style. I didn't take the yoke of my old t-case before I scrapped it. If I can find a yoke that matches my flange for my drive shaft would the splines on the front output shaft be the same if it is np241c also? Mine is in a 3/4 ton. I wasn't sure if the output shaft for the front is different if it's a 1/2 ton