Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.
ya, the geometry of the lift/frame will be tweaked. i would probably get that frame fixed before you get a lift.
A) ok I just bought 2in blocks for my 3/4 ton burb and was going to crank the torsion bars to make it level. now im scared cause i dont want stuff breaking from the stress.
so instead i might do a 2 inch body lift but i had a couple of questions.
1: will it pull to much slack on brake lines, wires, etc.
2: wont it effect the 4wd linkage, e-brake, and gas filler neck.
3: the motor mounts are on the frame so the motor will sit 2 inches lower than everything else, wont that cause some overheating? any help would be great. Thanks
Well if you don't crank, what's the best way to get rid of texas rake then?
i guess that all depends on if that is the only thing your looking to do.