***SUPER BIG/LONG POST***
But it is an LED thread, right?
I guess I'll go ahead a post all my LEDs and LED mods.
The first thing I did was do underglow and grille lights. I took some 5m (16.4 feet) long LED strips I cut to length and placed behind the grille, along the sides, and under the front and back of the truck. The color I chose was green, because that's the accent color I chose to go with... Plus the Yukon is green. It was roughly $20 to $25 with the 5m roll of LEDs, relay, wire, and switch.
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
Next I got some bulbs for my side markers and front turn signals. On my Jeep, years ago, I got the SMD 5050 LEDs and I loved them at first. But over time I've come to not like that style because they are very dim in the daylight and you also can't really make out the brightness difference when the turn signal was on.
So I knew when I did the LEDs on the Yukon I was going to spend a little more money and be more happy in the long run. So I knew I wanted a Cree style LED so I went with some green 50w cree 1157 LEDs. They were $70 for all 4 but they are well worth the money and you can get them in multiple colors and wattage for cheaper. They are so much brighter and you can actually see the difference in dim and bright. You can also see them in the daylight without a problem. If I'd change anything, I'd probably get the 80w versions just for more brightness.
You must be registered for see images attach
You must be registered for see images attach
I also got some green COB 194 LEDs for the marker lights... if I'd change anything, I would get the SMD 5630 that has 6 LEDs in one bulb. I though the COB would be better since I had some problem with the 194 SMD 5050's in the past on my Jeep, but the COBs aren't as bright. I don't remember what I paid for the COB 194's
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
Next I did the gauge with the standard green SMD 5050 194 LEDs, 6 of them. Again, don't remember what I paid for them.
You must be registered for see images attach
You must be registered for see images attach
Then I got me some green 80mm COB halo rings, 4 of them, to put into my eBay halo/projector headlights. I think $30 for both sets. I also got some 5mm green LEDs from superbrightleds to change the 3 white LEDs that are in the headlights.
If I'd change anything, I'd get some RGB (colorshift) halo rings instead of single color. Which I actually have, setting in a box, waiting for me to change them out. The 80mm RGB halo rings I got were $60 for 4.
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
Then I installed clearance/cab lights and used green SMD 5050 194 LEDs.
You must be registered for see images attach
Then I got an ID bar for the back. It has the standard 3 red LEDs and then the rest are reverse lights. Was $15.
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach