mdnky
Latest activity Postings About
-
-
Buy two. Whenever you run out, you have a spare available, and then you replace the spent reel immediately. I learned this the hard way... -
Some of the prettiest welds on the truck and they will never be seen once this bracket is installed.
-
Nice welds mate.
-
I use deer skin gloves, they are thinner so beware off picking up hot stuff as they really only keep the UV light off your skin. Do you...
-
Once you get the basic settings in then it's just practice, and over time you will develop a technique that works for you as everyone is...
-
The tbi is definitely great for what it’s intended to do and i loved it for a long time, but it’s about time for it to go… need to make...
-
Well I’ve put a few thousand miles on the irs swap, including a pot hole or two and it’s still holding strong.
-
I have a few reasons I’m debating doing the IRS. I’ve seen it done on c10s and the results seem to be great as far as handling and ride...
-
It's been covered on this site before, but one of the Van Halen trucks had IRS from a Corvette under it. Along with other drivetrain...
-
This is a 6th gen subframe, seems fairly straightforward to mount as it’s only welding some tabs to the frame and 4 bolts holding it...
-
Yes, that axle is junk. It's a hand-grenade with the pin out. In most cases, they came with crappy rear brakes, too. GM had no...
-
What size (diameter) tires will you be running? What do want your RPM to be when you go through the lights? In what transmission gear...
-
Your transfer case 2.72 gear ratio is the 4wd low-range gear ratio, 4wd High-range and 2wd are 1:1 ratio. No need to do anything with...
-
Never heard of an NV4500 being put in a 1500? We talk about it here plenty :) you could absolutely order it. But yes, *normally* a...
-
mdnky replied to the thread 97 K1500 DD/Overlander.Thanks! I haven't used their stuff before, but I know a few Jeep guys who have. Based on what I've heard from them, and what I've seen...
-
-
-
Loading…
-
Loading…
