So here's the thing. I hit a pothole. The pothole hit back LOL.. Suddenly the truck pulls slightly to the right... Alright, guess I'll go have an alignment done. NOPE! Was told the upper ball joint on the right and both lowers needed to be replaced, along with the left tie-rod. Alrighty then! Well, you could very well say I went all out. THIS happened.
You must be registered for see images attach
I replaced everything. Gearbox, pitman, idler, all tie-rods, all four ball joints, along with all four shocks while I was under there (the old ones wouldn't even try to expand). MOOG components all over the front, SensaTrac shocks on all four corners. Rides sooooo nice
Had to do some engine work a bit ago.. Truck wouldn't start. It would crank forever, but not start. Turned out to be my distributor cap crossfiring, at best guess... I had a random misfire as well, tho not noted by the computer, I could feel it. So I replaced the cap and rotor. The plugs and wires had already been done so I'd pretty much ruled them out. During this, I replaced the fuel pump because Chevy, and the fuel filter. While I just happened to be all up in the engine, I went ahead and did the MPFI upgrade. A couple weeks later, the water pump started leaking, so that got done too.
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
Now, about that switch panel. Originally, I was gonna keep it real simple, just put in a switch for the amps (next to the amp remote), a switch for each e-fan override (left two), etc... It got blown all out of proportion
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
And then... I thought, why not. I have ALL THESE SWITCHES. What to do with them? Oh idk.
You must be registered for see images attach
lol. So there's that. Oh and the switch on the far right only controls whether the LEDs come on or not.. So I can turn the switches on without the LEDs if I want. And I had to do some fun bit of wiring for it, but the left two switches that run the e-fans? They light up even when the switches are turned off, to show that the PCM is running them
I want to put my CB radio in alongside my 2-meter/70cm radio (I'm a ham radio operator, KL2CD). But I have this... Aversion, to putting holes in my dash lol. And, they have to stay out of the way of the shifter! So.... I put them under the driver seat instead! Oh and I had to make my seat rails not so ugly. So BLUE they became!
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
And the final look... I'm going to replace the Midland radio with my Road King previously reserved for the semi truck lol.
You must be registered for see images attach
Picked up a decent looking ceiling console, and now you can see my digital mirror working too lol.
You must be registered for see images attach
Wiring that..
You must be registered for see images attach
I'm not gonna bother with lighted mirror visors so I just grounded it to the ceiling using one of the mirror harness connectors.