well i got an update for ya'll! been a while since ive posted anything on here but lets just say ive made a few changes
so i got fed up dealing with auto transmissions and picked up a sm465 and np205 for cheap!
You must be registered for see images attach
obviously pretty gross so i had to clean it up a bit and inspect the internals.
You must be registered for see images attach
reverse gear was a little too worn for my taste so i replaced that along with the idler gear with a rebuild (seals, bearings, sincrose, etc.)
You must be registered for see images attach
got the pedal assembly and master out of a 90 burb with the same trans
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
had to cut the floor...obviously (worst part
)
You must be registered for see images attach
ran into a slight clearance issue with the drivers side header when getting the trans in
You must be registered for see images attach
so i had to remove the header cut and weld a new pipe on
You must be registered for see images attach
that was the only hiccup i had getting it in then the rest fell into like it was supposed to
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
then after all that hard work my pass side front bearing in the hub decided to go out so know shes sitting in the driveway till i work up the funds to rebuild the outers. you'll also notice that the 37s are missing
You must be registered for see images attach
You must be registered for see images attach
i pretty much traded a guy for a set of 42" tsls
You must be registered for see images attach
so ya thats where im at now