Electric fan wiring

[3linkedchevy]

Yeah, the picture I took of the plug (between the plug wires) is between the 6 and 8. So that is a spot I can put the sensor?

 

[TylerZ281500]

yea itd be the same as the drivers side head with the sensor in it, both are threaded.

 

[3linkedchevy]

Oh nice, that should work perfect then. Should I use any teflon tape or anything?

 

[TylerZ281500]

i usually use at least one pass of teflon tape on all sensors that go into the block, just on the threads as you probably know. if its too bulky it buckes up and its a mess so one neat pass across all the threads would do you fine.

 

[3linkedchevy]

Cool, appreciate the help. Maybe I can attempt the install on Sunday.

 

[TylerZ281500]

lemme know how it goes. post pics after completion

 

[3linkedchevy]

Will do, and sorry for kind of over-taking your thread! lol

 

[TylerZ281500]

not at all. few good ideas passed around. now i just need help with my wiring dillemas.

 

[narizon]

That's the one,just make sure you hit it with some type of spray lube at least 24 hrs ahead and you need a good totally square 1/2" extension not a rounded out one or else you'll be using some weld rod too.Do it yourself.I had an extra set of hands that day,not good.The 3/8" plug got stripped.
No tape hear just put a little anti seize on the threads of the new temp switch.Never has leaked.

 

[TylerZ281500]

i used a punch and a crescent wrench on mine when i swapped heads. and yea antisieze would work too.