I searched through most cab mount related posts and if there’s a thread on replacement, I didn’t see it. I also checked YouTube and the videos I saw always seemed to skip over the jacking of cab. Most videos were a waste of time, with issues I don’t have. I kinda remember reading a few years back of someone replacing mounts and using a 4x4 timber when lifting cab or was that being used to tilt bed in a fuel pump replacement.
Anyway, who here has done it? I’m thinking with them all loosened up, what is best jacking procedure? I don’t want to just jack in one area and torque and twist the cab unnecessarily. For instance, do you jack the driver side and then say passenger side? Or, is it a rear cab to front jack. And that doesn’t even account for what’s happening to front of truck with the core support mounts.
Anyway, who here has done it? I’m thinking with them all loosened up, what is best jacking procedure? I don’t want to just jack in one area and torque and twist the cab unnecessarily. For instance, do you jack the driver side and then say passenger side? Or, is it a rear cab to front jack. And that doesn’t even account for what’s happening to front of truck with the core support mounts.