3" Body Lift, 2" block and crank, 16x10s 33s

[RHamill]

I know these type of threads get annoying, but because everyone has a different set up it seems, it will be easier for me to just post my own specific details and recieve a quick and accurate answer.

I have 3" body lift, 2" block in rear w/ add a leaf (from P.O.), also I cranked T bars up a tad, so it does have a little rake (which I prefer anyways).

I have 305/70r16 Dura-tracs with 16x8 wheels 0mm offset.

Is it quite possble for me to run 16x10s, anyone have a similar set up, I want the deepest wheel I can get, so less backspacing is a plus if I can fit it.

 

[badazzbulldog]

yes it will work my buddy has the same setup as you with and is running 15x10's with 35's and just had to trim the bumper corners a little

 

[JAW's]

I have the same set up:
16x10 Pacer wheels (unknown offset/BS) with 305/70/16 BFG KM2s
3" body, and a 3" block and keys.
(before the rants begin about the keys; they did give My truck a little more lift and were needed. However this could be do to sagging T-bars)

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

[/QUOTE]