I have a 0411 from him that I never used. I lost the paperwork/email that showed the pinout. It needs the 4l80E deleted. I;m running a TH400 in the jeep. I don't have the part of the harness that has the OBD2 port. Is there a workaround?
I have a complete 5.7 with ecm and engine wiring harness from a 97 truck that I want to swap into a jeep CJ 7. I do not have the interior harness. Which wires do I have to connect to get it to run? Does anyone know or can point me in the right direction to run this engine in a stand alone...
Being that I am doing a full rebuild and haven't purchased any parts yet working with a engine tuners and machine shop's recommendations will be the key to my goal.
I am shooting for 15 mpg on the highway. I was planning on using Gibson headers with a aftermarket muffler. Also improvements in the airflow and fuel delivery. I was thinking of a good torque producing camshaft, 36lb injectors, and mild port work on the heads. Lastly, tuning the 411 pcm to...
Building a 97 l29 454 for my suburban that has a nv4500, 3.73 gears and 31 inch tires. So I am looking for the best highway mileage and torque with this build. What recommendations do you guys have for cams, fuel injectors, machine work to the heads, tunes, and anything else.
Excellent looking suburban. I have a 1997 K2500 suburban that I am working on. Three years ago my 4l80e toasted and I swapped in a Nv4500 5 speed. Just picked up a donor suburban with a 454. Going to rebuild it and swap in next summer. Can you elaborate how you removed the trim on the sides of...
I want to say you will have to use the 454/4l80e harness you have for question 2.
Question 3... Any 4l80e should work as long as the splines and transfer case will marry and has a place for all the connectors. I think as long as you got a 96 and up trans you will be ok.
Question 4. No adapter...
I have a Ford Dana 60 in my garage and was thinking about converting my k2500 suburban to a front solid axle. I changed my mind though. The cost to regear and rebuild the axle plus all the suspension/steering parts is too much. I only drive mine on the beach in the outer banks anyway. I am...
Yeah I ditched the sbc 400 idea. Without a roller cam, I don't think the 400 would make the torque and horsepower at lower rpms. The thicker harmonic balancer also had me worried. I will build a 383 or do a 6.0 liter swap. I like the stroker kits that Texas Speed sells for the 6.0!
I don't want my truck to be down for more than a weekend or two, so i would need to have the new longblock on the stand ready to go. I called 3 machine shops in the area, Two were backed up with race engines and told me to buy a crate motor. The last one wants to assemble the short block which...
No apologies needed. I learn something new on every post. I have only built a couple of carbed motors so I am like a sponge trying to soak up info. The reason I am asking about this 400 is that it does not need a rebuild and is basically free to me. It looks that there isn't any benefit power...
No electric fans for me. I am wanting to do this upgrade for better towing. I just recently installed the hd radiator, waterpump and fan clutch. My L31 has 248,000 miles is a little tired and is leaking oil. My friend has offered his sbc 400 to me and i would like to make it work if it doesn't...