Recent content by low4x4
-
Tbi edelbrock intake manifold ? Anyone?
i should have one hanging around, but it might be ported to two inch holes due to me running a 454 throttle body on the small block 350...i will have to look around- low4x4
- Post #30
- Forum: Engine Performance + Maintenance
-
any one dipped ther truck yet
if you want to seal it next time look into dip armor....you can do pearls in the mid coat and then use dip armor and it will be protected from chemicals....standard plasti-dip will react to chemicals....i had a oil cooler line leak and the oil left discoloration in side the wheel well...also...- low4x4
- Post #10
- Forum: Paint / Body / Detailing
-
any one dipped ther truck yet
so here all the details...just finished 1200 hrs of body work doing the wide body kit that i custom made myself...everything was sealed in 2k primer and wet sanded to 2000 grit...as far as the dip...the cost was about 1500 which included the pearls for the color and the advanced turbine...- low4x4
- Post #5
- Forum: Paint / Body / Detailing
-
any one dipped ther truck yet
i recently dipped my truck with plasti-dip...tsunami hypershift...itchanges from green to blue and then to purple depending on the angle you are looking at it...- low4x4
- Thread
- Replies: 9
- Forum: Paint / Body / Detailing
-
Lowering A -1989
when lowering the front remove the bump stops ..when I did it I removed all the front end and rebushed it with polyurethane the shocks I use front and back are edelbrock factory height mono tube- low4x4
- Post #7
- Forum: Lowered and Bagged Suspension
-
Semi float rear end
i did the swap and installed new springs at the same time...the ebrake cable for a long bed reg cab works with the extra cab short bed...the perches on the 14 bolt are shorter so a spacer or a couple extra springs will keep the same height....the difference is about and 1 inch+/-...use new u...- low4x4
- Post #3
- Forum: Stock Suspension + Bolt On Kits
-
exhaust help please
I ran 3" edelbrock headers and cat back with there flow thru muffler with out the cat....sounded good -
Core shifter NV3500
no pics sorry...but I will look in my history files for something- low4x4
- Post #15
- Forum: Transmissions
-
96 Tahoe code P 0300
when I get my p0300 code I change out the cap and the fuel filter and everything is back to normal for a year- low4x4
- Post #5
- Forum: Engine Performance + Maintenance
-
Tbi chips(jet and Hypertech)
i have dynamic efi added to my pcm and have been able to retune every time I upgrade https://www.dynamicefi.com/EBL_Flash.php- low4x4
- Post #13
- Forum: Engine Performance + Maintenance
-
Trans/Driveshaft clunks and falls on its face
to check the u-joints, you should be blocking the wheels and taking it out of gear with the e brake off..then check the joints for play- low4x4
- Post #3
- Forum: Transmissions
-
New Member from RI
Welcome from Ma. J.Perrys garage in taunton ma is a good place to look for parts he only does chevy /gmc- low4x4
- Post #2
- Forum: Introduction
-
-
Best collector gaskets that will last!!!
they are factory bolts with factory header/collector gaskets...you might find something in the help section at the parts store -
Best collector gaskets that will last!!!
I edelbrock shortys and replace mine every year with factory ones...use bolts with spring to keep the bolts tight all the time
