Ok thanks. The cam I'm not sure because when I called summit they said it would work fine with factory computer, Tbilisi and the valvetrain. Ill check for wires and such.
Ok update as of this morning. Last night I took out the fuse for the ecm. Put it back in and drove it around for a while and it ran and idled fine. This morning I go to start it and it started up and had a really low and rough idle. Then I turned it off and it won't start. Check engine light...
ok. well i had swapped out the ecms when i bean doing the swap so the battery was unplugged when the ecm for the 350 was put in. does that count or should i unhook it again?
also even when the truck is warm it idles really low and takes a while to get the idle up. the scanner also showed a MAP sensor code so i replaced that. made some improvement but like i said even when its warm the motor takes a bit to idle and even then it still seems a bit low. i mean ive only...
hi everybody. like the title says i did a 350 swap in my 94. it was originally a 305 but i swapped in a 350. the 350 has a 20 over bore and a comp lw end cam. nothing wild its basically stock. i took the 350 out of a junk truck and completely rebuilt the motor. everything is pretty much new. i...
ok guys ive got a real problem and i have no idea where to start. i have hids in my truck. theyve been in it a few months and i have never had an issue. but tonight they came on with the truck off, the key off and the healight switch off. now if i got in the truck and started it they would turn...
hi guys. i have a 1994 Chevy k1500. i have a 350 built for it that has all new internals with a 20 over bore and a low end cam. heads were redone and have all new parts also. my trans is going though and i want to rebuild it. i found 2 kits and i cant decide which to choose. and if anyone here...
Ok. I was only looking at pushing 6 to 8 psi on a totally redone 350 with a .20 over bore and all new internals. So what would you recommend I do to the motor to do this?
im looking into putting a procharger on my 94 k1500. i just had a 350 bored .20 over and the heads were cleaned and rebuilt. all the internals are new and the block was dipped, baked and painted. so the motor is totally fresh. i was wondering what i had to do to put a procharger on my truck and...