Search results

  1. G

    Where does this connector go to?

    I was thinking that but I have pulled out both radio associated devices out and looked at them and dont see any more plug in spots avaible. Not able to realy look at the device/unit where the antenna wire plugs into though.
  2. G

    Where does this connector go to?

    Hey guys, just finishing up putting my dash together after removing the entire thing lookin for a bad wire. Cant seem to find where this little connector is supposed to go to. I have it comming out of the ash tray at the moment, Any thoughts?
  3. G

    Can a bad turn signaling switch cause an ECM, IGNITION switch to blow?

    Hey all, A few weeks ago I posted about my truck blowing the ECM, IGNITION fuse. Quick follow up on the situation; I could drive it for what seemed like about 5 mins, then the fuse would blow. It was prety consistant with the duration of time needed to make the fuse pop. Anyway, got to...
  4. G

    Blown fuse on the 10 amp Ign, & Ecm location in fuse block.

    Here's a long shot posting on this again thread again, but as far as when the fuse is blowing, it happens when driving it for about 5 mins. Then it blows and while coasting I can plug a new fuse into the box, throw it in N and crank it over. It will run for about another couple mins, then blow...
  5. G

    Blown fuse on the 10 amp Ign, & Ecm location in fuse block.

    Well, drove it home and its eatin fuses like candy. Any commmon places or just start plulling wires apart assotiated with this fuse?
  6. G

    Blown fuse on the 10 amp Ign, & Ecm location in fuse block.

    Hey guys, was out driven my truck when I lost engine power. The 10 amp. Ign, & Ecm spot on the fuse block under the dash blew. The fuel pump stoped working when this blew also (must be on same circut). Anybody point me in the right direction. Common thing (or shorting spot to look at) with...
  7. G

    Can I install 10 bolt posi guts in my 10 bolt open diff axel?

    Ok, sounds like it would be possible from what Im hearing, but after hearing the part of getting the same wear pattern set, I could see a big pain in the butt trying to get this thing to shut up. Like I said, I dont know a whole lot on spefications with diffs (what fits what, ect.), but since I...
  8. G

    Can I install 10 bolt posi guts in my 10 bolt open diff axel?

    Hey guys, Im sure this question is on here somewhere on the old threads, but I have spent a fair amt of time looking and no luck. Im not real experenced with rear-ends, but here are the details. My 4x4 is a 90 GMC K1500 with a GU6 (10 bolt- open diff) rear end, 3.42 gears, 6 lug axles, and...
  9. G

    Less than 8 miles on new crate motor, smokes white and has slight tick at idle.

    The company is Grooms Engines out of Nashville T.N. But actualy I bought the engine from a salvage yard in S.D. Of course its not a used motor, the salvage yard is just a dealer for this company. I dont want to knock these guys yet until I find out if I screwed up or them. I did notice the...
  10. G

    Less than 8 miles on new crate motor, smokes white and has slight tick at idle.

    Hey everybody, Just got to drive my truck tonight after finishing motor swap. Already having some issues with engine. Let me give a little history of the vehicle first. I bought the truck with a blown engine (overheated). Motor was a total lost cause. Got a crate engine, had the intake...
  11. G

    Can these connections be left off?

    Thanks guys for helping out another newbie on this forum with all the input. I figured it may be something like this, but always better to ask than find out the hard way! Keep up the good work!
  12. G

    Can these connections be left off?

    Sounds good, Ill check one more time on the back of the distributor, but I swear I didnt see anything. That coil connector is very dirty (black corrosion), like its never been plugged in. Thanks again.
  13. G

    Can these connections be left off?

    Thanks for the quick reply, so with the alternator hook up, it IS ok to just have the one wire hooked up and everything will still work all right?
  14. G

    Can these connections be left off?

    Here are two connectors that I dont know why these were not hooked up when I got this truck. the truck is a 1990 K1500 5.7 with auto . The one is on the coil and the other is on the alternator. Any ideas? Thanks.

Latest posts

Members online

Total: 914 (members: 12, guests: 902)

Forum statistics

Threads
65,137
Messages
1,406,352
Members
53,206
Latest member
ToniM

Share this page

Top