Search results

Power windows not getting power after adding push-button start

Thanks for confirming delta. Should be easy enough to just cut the brown in the harness and wire it with either the orange connection (the one I would choose) or the ignition 2 connection. Interested in knowing if this solves your problem OP.
- Powerslayer
- Post #10
- Jan 21, 2020
- Forum: Audio + Electronics
Power windows not getting power after adding push-button start

Looking at all of my poor quality diagrams, I've found one that shows "hot in run" feeding the power window circuit (30 amp fuse) out to a yellow wire going to the convenience center which powers everything. What I would do is check for continuity between the ignition switch wires and the power...
- Powerslayer
- Post #8
- Jan 21, 2020
- Forum: Audio + Electronics
Power windows not getting power after adding push-button start

Do you have a link to the push button so I could take a look at it? Or better yet just the wiring instructions? Would also like to see all the wires you connected and cut.
- Powerslayer
- Post #3
- Jan 20, 2020
- Forum: Audio + Electronics
P0300 1996 K1500

The shaft was loose in mine. Had vertical play as well as a considerable amount of horizontal play compared to the new one. I got one like this, the actual one I had bought is unavailable now, but it came with a cracked cap and the rotor was very warped. Super cheap parts were sent out there...
- Powerslayer
- Post #21
- Jan 20, 2020
- Forum: Engine Performance + Maintenance
P0300 1996 K1500

You say you put in a distributor from another truck, do you know for certain that distributor is good? I fought with a P0300 (read using a good reader that can read individual cylinders as well) for around 8 months on my 97 c1500 before solving it. Initially swapped wires, plugs (some were...
- Powerslayer
- Post #19
- Jan 20, 2020
- Forum: Engine Performance + Maintenance