Recent content by Pappy G

  1. P

    No start

    I have a scan tool but I am not real good at using it. It will show live data but that is is all greek to me. I think If I plug it into a computer it might tell me more.
  2. P

    No start

    Had to swap transfer case to manual as well. I don't think this far back had a limp mode. It should have taken 3 months to hit limp mode if it did. Yes I have code for shift solenoids because there are not any now.
  3. P

    No start

    1. I am going to pull the cap off today. I don't think it is the problem though or it would not have started when I changed crank sensor. Yes I have spark. Timing was fine when it quit. No reason for it to be out of time now? 2. I get a couple 02 codes I expected that. 3. It has the spider...
  4. P

    No start

    I am at my wits end on this truck. 98 GMC Sierra 4wd. 350, 4 speed. Yes we converted it from auto to 4 speed.... Truck was running fine, then died. Cranked and acted like it wanted to start but coughed and sputtered. Zero fuel pressure at rail. Ran diagnostics, new fuel pump installed. Good...
  5. P

    Engine died no restart

    It appears to have been loose wire on starter.
  6. P

    Engine died no restart

    The motor in my 98 GMC quit like I had turned off the key. I have power to everything but starter. Checked all fuses in fuse box and under hood.
  7. P

    No pedal while running.

    Yes , no leaks.
  8. P

    No pedal while running.

    About 6 months ago I replaced booster, master cylinder, calipers, brake cylinders, hubs rotors. Had good pedal and good brakes. Truck broke down and sat until a couple days ago. I have great pedal when engine is off. As soon as I start the engine, I lose all brake pedal?
  9. P

    Start then stall

    As it turns out, the cranks sensor wire had a break in it.The new crank sensor I put in was actually faulty as well.
  10. P

    Start then stall

    I had the start stall issue prior to changing that.
  11. P

    Start then stall

    Throttle position sensor not TBI.
  12. P

    Start then stall

  13. P

    Start then stall

    I hope I am in the correct place for this thread. 98 GMC Sierra 5.7 with automatic converted to 4 speed transmission. Truck ran great for 2 weeks after the tranny conversion. Developed a short in wireing. 2 different mechanics put new ignition switch in thinking that was problem. The put...
  14. P

    Center Armrest/Console Parts and or Repair

    Looks just like the one in my 98. I am trying to figure out how it all comes apart.
See more

Latest posts

Staff online

Members online

... and 11 more.
Total: 1,312 (members: 61, guests: 1,251)

Forum statistics

Threads
65,061
Messages
1,405,025
Members
53,032
Latest member
Saintsfan1225

Share this page

Top