Recent content by Just Nobody

  1. J

    Canadian/Mexican Trucks in the USA?

    One USD is Approx 0.70 Cents CND
  2. J

    Canadian/Mexican Trucks in the USA?

    They make 30% + on just the dollar exchange alone.
  3. J

    Tonneu cover 6 FT bed 1994

    Dodge and Chevy dimensions are real close, I just installed a 99 dodge ram soft cover on a 88 dually , fits not too bad. If you were looking for used...
  4. J

    Skylark's dually

    That tire/wheel combo looks great on that truck.
  5. J

    Bleeding Rear Drums..?

    For bleeding by myself, I do gravity bleeding
  6. J

    HEI swap

    Might want to look at this type of switch for your oil switch, or just add it to your fuel pump wiring. https://www.racetronix.biz/p/pressure-switch-2psi-spst-m-p280s/hps-2
  7. J

    Frame Rust: When to be concerned?

    I have welded patches in that area before, it one of the first places to look when buying, especially on the drivers side. Clean it up and see how it looks. I use coreseal for a rust neutralizer.
  8. J

    Full parts cannon and still runs rough

    Scan tool would be great, it an OBD1 and the paperclip and count the blinks is the only way I know how to read codes. Even using the paper clip trick it still might shine some light on the issue.
  9. J

    Full parts cannon and still runs rough

    Check the IAC plug- My 92 had that plug in the wrong orientation as a result of the lineup pin/tab was broken and the plug looked like all was ok but it was 90 degree out . I bought a new plug and rewired into harness, all was good after. Also check the distributor module and the part that the...
  10. J

    OEM bucket seat bolt hole differences?

    They are from a 92/93 and newer. The 91 had two armrest. I have two blazers with same interior,colour and all, both with power seats. The black one is a 91
  11. J

    Has anone here actually done a 4wd to 2wd conversion?

    I have seen two 2wds converted to 4x4, they were both solid axle conversions.
  12. J

    RCLB K2500, K3500 Differences?

    The frame designs are the same, some thickness and some height differences between the light and heavy duty frames. There's a weld below the front door on all the trucks ,it where the C-channel changes to square tube part of frame. That factory weld can be removed and a different front clip can...
  13. J

    Engine replacement/rebuild recommendations

    Look at GM parts engines,they were around $2900-3500 CND when I was looking for an engine. I rebuild the original for $1800 with parts from rock auto and had the machining done locally. I didn't care about 2 or 4 bolt mains, i wasn't building a racer, just a decent runner.
  14. J

    Upper ball joint boot stuck up?

    Not sure if i want to know why, but how did you get the oil in the ball joint anyways.?
  15. J

    95 w/t 4.3l manual transmission -does 95 year only apply

    No.
See more

Latest posts

Staff online

Members online

Total: 1,542 (members: 37, guests: 1,505)

Forum statistics

Threads
64,476
Messages
1,394,724
Members
51,754
Latest member
Riccoon

Share this page

Top