Thank you again guys for your input..
I found the leak was endeed the oil pressure sensor...leaking under the brass connector.... So tomorrow I will add some kind of seal or something cause I thigh it up more but still leaks a bit.
On the shifting issue still no luck.
Remove the governor...
Hi guys so today I went and try to install the govenor with the cover and gasket... I hit the cover with a pice of 2x4...and hammer.... And I think I pushed the center alittle too much... Not sure if it's hitting the back. Of the governor inside..
Cause when I start the truck..
Noo...
Sorry again guys here...
Need some guide on where this wire goes I have one black with diode thicker cable ends on a purple color...?
It comes from the tranny side...?
I believe.. Togeder with 4 more wires.. They go through a little tube behind the rear right head towards the starter to front...
Ahhhh finally... Jajajaj lol
Got it running... You won't believe..
So I was trying to remove the distributor cap... And decide it... To first remove coil.. To distributor spark wire to check for... Spark at the coil with a screwdriver... Guess what..?
It cranked like a new truck nice and...
Please Help guys...
I install harness... As to my knowledge everything is fine
.. Now.... It won't start hard to crank feels like it wants to go but won't crank... Feels like week battery or starter..
So I went ahead order new starter same thing..
New battery samething....
Change negative...
Well I got the harness in.... And coil wires.. Cap rotor... But missing just 4 wires won't match... I got no reading from the conector C100 to the wires showing in the picture......?
With my voltmeter... No continuity.. Weird.. ... Any clues...?
Thank you very much for you rhelp on the diagrams... A lot of help.
But there's some miss matches also in some diagrams... Like wire color codes on some circuits...
So now I'm almost done with the harnees... Just finished installing it on the engine.... But I have 2 wires that wont match...
Ok so I'm getting closer.. With the harness but now I'm kind of lost with some of the wires coming from the tranny... I'm talking about the bundle coming from the transfer case to the front of the truck going throu the little tube under the ground on the Rh top head... To the bottom of the frame...
Anybody can pitch in or guide me to a good lynk with some good diagrams for the wiring is has to be 91 or 92 cause then It will change.. The wires and some different diagrams... Any help will be greatly appreciated.
Thanks
Thank you guys for your feed back is really a predicated...
I went to the yard and found a decent clean tbi 350 harness for cheap 27bucks..with the pump relays.. The wiper mortor conector.. All the block conector... Map sensor..
.. The only issue is that is for a 4l60e tranny cause has more...
Hi guys newbie here..
Just got my firs 2door yukon 1992 tbi 350
With the engine just replaced only 24k miles...
Bought it from this lady.. She said cut on fire whe se was driving stoped and someone extinguished the fire...
Parked it.. And decide to sell..
So I went and bought it.
Need some...