I’m swapping a 14 bolt in and it’s well documented. I know I need a conversion u joint. I have one on order.
What I need to know is regarding the u bolts. The thicker axle tubes mean I need new u bolts and the plates. I bought a rear axle from a source through my work. I isn’t coming with...
I’ll just be buying new. I actually work as a service advisor and get discounts on stuff especially compared to retail. Just needed to confirm once the hub is switched it bolts in.
So parts I need are jb6 calipers, rotors, and pads. Then the f44 hub and bearing assembly.
Will this clear a...
Eh I just like big brakes in all honesty.
After searching more it appears I should do jb6. So I guess back to the original question, it just bolts in after swapping the hub and bearings assembly?
I found this. Appears to be bolt in but looking for some quick confirmation so I can get parts...
I had a separate thread but figured this was the way to go.
I have a 89 k1500. I’ll be upgrading to hydroboost and a 1.25” master cylinder. I’ll also be upgrading the rear end from the 10 bolt to a 14 bolt.
Apparently I have the jn3 rotors and calipers. I measured the rotors and they’re...
There isn’t anything wrong with fords, as long as the e4od is built to be reliable. You have a c6 if I remember right from reading. I own a 1996 bronco that I am in the middle of a Restomod project. Built 351w and a zf5. Converted to an 8 lug using a f250 rear end and Frankensteined the...
89 k1500. I have a hydroboost and master from a 94 k2500 going on. Waiting on the pedals because the place I got my nv4500 forgot them.
- Do I need to swap out the Saginaw for one from a k2500/3500? I looked at one and it appeared larger than what’s on my 1500? Maybe perspective was messing...
Sorry for the multiple posts regarding somewhat related subjects.
I have a 89 1500 I’m swapping a nv4500 for the 700r4. Yesterday I put an order in for a bw4401 but I realized there are some issues. The bw4401 is for an electric speedometer where my 89 is a mechanical speedometer.
I...
Ordered a bw4401 transfer case that came attached to the transfer case. This looks like a beefy ******* of a transfer case. Does it require its own crossmember?