Yoke on 4l80e

[dylan5299]

Hey yall got another Q for you. I bought my truck on Saturday and the guy had both driveshafts in the bed of the truck since there was no tranny in it and he never got around to it. My question is, is there a good way to clean that up? I cant imagine all that rust could be good. I cant even run my fingernail across any of it. If I'd be better off getting a new one any suggestions on where I could get one? I tried googling the number on it but I couldn't find it. Same thing with the front shaft too. Any good way to clean all that up? Thank you all.

Oops almost forgot to ask about the spot where it looks like someone patched the driveshaft. I just wanted to know if that was normal.
Sorry for all the questions!

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

 

[BIG_KID]

Get your sandpaper out. That "repair" is a balance weight.

 

[Jorge6.5]

What he said. But honestly the inside where the splines are, that could also be rusted and most likely won't slide over the shaft

 

[Terrick down Under]

I would start with a scotch bright pad from the kitchen with backing soda and slowly clean it, before you attack it with 800 wet n dry paper