96z71sas
OBS Enthusiast
Thanks for reply I should have taken pic of good side it was welded clean and everything was real straight the front of spring must of been hit the bumper is straight but the condenser bent rad support I’m going to measure frame first probably cut all off and start over thanks again was just asking other opinions1. This looks like somebody's sloppy mistake in a cut to the rail.
2. This looks like a crack.
You also need to realize this bracket it twisted and otherwise fubared out of alignment with the spring.
You start by measuring the truck frame to make sure it's not bent, then measure the suspension mounting points to make those are square to the frame, Then you can begin to diagnose suspesion/differential problems. Measuring the tires to the spring pack means nothing at this point and the one spring the eye has been bent open so it's trash.