resistance check for ignition control module

[Sully]

I just re ran the codes on my truck.... P0336 and 339

DTC P0336 Crankshaft Position (CKP) Sensor Performance

DTC P0339 Crankshaft Position (CKP) Sensor Circuit Intermittent

guess what I'm changing out.

 

[FastOrange]

I just re ran the codes on my truck.... P0336 and 339

DTC P0336 Crankshaft Position (CKP) Sensor Performance

DTC P0339 Crankshaft Position (CKP) Sensor Circuit Intermittent

guess what I'm changing out.

Hmm, must be it

 

[Sully]

now to figure out the easiest way to get it off

 

[Sully]

i know its in the timing chain cover, but does anyone have any knowledge of how to get out without pulling the rad, fan, water pump, and timing cover off?

 

[FastOrange]

i know its in the timing chain cover, but does anyone have any knowledge of how to get out without pulling the rad, fan, water pump, and timing cover off?

:dunno: Im no help here sully. But maybe climb under your truck and look?

 

[Sully]

its in the slush right now

 

[Sully]

looks like the hamonic balancer has to come off.. can someone with a haynes or chiltons manual check into this for me?

 

[FastOrange]

I will see if i can dig up my book.

 

[Sully]

REMOVAL & INSTALLATION

Disconnect the negative battery cable.
Detach the sensor harness connector at the sensor.
Unfasten the retaining bolt, then remove the sensor from the front cover. Inspect the sensor O-ring for wear, cracks or leakage and replace if necessary.

To install:
Lubricate the O-ring with clean engine oil, then place on the sensor. Install the sensor into the front cover.
Install the sensor and tighten the retaining bolt.
Attach the sensor harness connector.
Connect the negative battery cable.

 

[Sully]

thats on the autozone site, but seems to easy. The balancer is right there