Sorry for not updating. I got busy, found I was missing a lot of stuff, had to order it all, wait on shipping, etc. While waiting I ripped everything off and had the uppers powder coated. here is the plenum and pass side runners:
https://flic.kr/p/WXbYkL
I had run all new fuel lines but decided to go back to stock lines. The new lines didnt look right and secure. So I took off about a foot off of the factory fuel lines (that were all up in the way of the runners), had someone weld 6AN bungs, and routed some PTFE lines from bungs to the rail.
https://flic.kr/p/WXbYHE
https://flic.kr/p/WXbZej
Sensors that have to be relocated are now relocated (TPS, IAC, etc). I am using an LT1 throttle body, since it uses the truck's style TPS and i dont have to rewire it. The IAC is different but i have an adaptor for anyway.
Tomorrow im going to bolt everything back up and turn the key and check for 14 psi tbi fuel pump leaks. If none then hopefully i can get someone over next weekend and help get in this 45-50psi pump and try it out then start it up.