About the only real challenge for getting the RC lift into the chassis was the upper control arm drop. It needed to be spread about 2''s. I cut the bracket in half, made little plates to be welded in to take up the space. It also meant that I had to make my own holes for it to bolt in. The psgr side had an access hole for a wrench, but not the drivers side. So I drilled another hole close so I could get a wrench in there to tighten it down. New bushings were pressed in the control arms and that's where I ran into a problem. While getting the old ones out, I accidently mushed one of the little side bushings in the press. With nothing to use, I turned to my lathe and quickly turned one out... having a lathe & mill, you can over come many obsticles
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach
You must be registered for see images attach