In the midst of this swap, and going to have a driveshaft issue to deal with.
Top is the NV4500 driveshaft, RCLB 3500. Bottom is ECLB 2500 4L80E driveshaft.
I need a shorter front driveshaft, and looks like the 2500 is the length I need, but it's going to be really close.
Question is, how much of that do I need to use. Can I slide the back shafts off the slip, and just swap those, or do I need to take them apart at the u joint?
Thanks
You must be registered for see images attach
Top is the NV4500 driveshaft, RCLB 3500. Bottom is ECLB 2500 4L80E driveshaft.
I need a shorter front driveshaft, and looks like the 2500 is the length I need, but it's going to be really close.
Question is, how much of that do I need to use. Can I slide the back shafts off the slip, and just swap those, or do I need to take them apart at the u joint?
Thanks