No lift and 31s

[1997k1500Calvin]

Do ya have a picture?

Si pictures plz, id like to see if a c2500 could stock fit some 32_33s

 

[95C1500]

Here's a stock height 99 'Burb with my 32's from my C1500. I would have to pull of the wheels off my truck to test drive the 'Burb with them. But it looks like it fits. Might need to trim the valance at full lock.

You must be registered for see images attach

Have anymore pics of this? This is prfect

 

[1989GMCSIERRA]

I don't mean to thread jack, btu those of you who ran/ are running 31's stock, do you think you could squeeze a 32x11.5 under there?

Yes. I had 32x11.5x15 on stock steel wheels. I tried 33s later but it requires pretty hefty trimming.
I'm currently running 33s on 15x10 with 3 inch BL. I was running 35s but they were huge and rubbed badly. I also had to regeared from 3.08 to 4.56. If I remember right I had slight power loss from the stock 235-75-15 to 31s

 

[95C1500]

have pics of the 32s?

 

[Ckeene]

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

You must be registered for see images attach

The avalanche is my wife's ....3/4 ton 496 big block

 

[ChevyDave]

Do they rub at all

 

[dangileri]

My standard cab short bed 2wd 5.0 has 31x10.5s- they only rub on the sway bar at full lock if i hit a bump or crevis in the road

 

[Ckeene]

Tires just kiss the fender flares on inside bottom at half turn. Should go away when I put a few miles on tires.

 

[ChevyDave]

Tires just kiss the fender flares on inside bottom at half turn. Should go away when I put a few miles on tires.

If the truck didn't have fender flares do you think they'd still rub?