brianblanton
Newbie
I have a 1995 chevy suburban. It is 2 wheel drive, 5.7 tbi. I have added a 1 inch lift plate between the tbi and the intake. It ran just fine for about 3-4 months after installing the lift plate. I rebuilt the tbi, and added a 14 psi spring. It gave me a lot more torque from the engine at low speeds. It was running yesterday, no problem. I went out to start it up this morning, and it sprays from the tbi injectors, it cranks but won't start. I have replaced the fuel filter this morning, and it still doesn't start. I have removed the relay for the fuel pump, and it turns over ok. I replaced the relay, and it try's to start, I just won't continue to run. Any help would be greatly appreciated.
Sorry. I have replaced the cap, ignition coil, wires. Left the old spark plugs in because I replaced them 3 months ago. I haven't checked the pcv valve. I will do it today. The problem is that it is an OBD1 computer, NOT OBD2. I'm not sure how to hook up my fuel pressure sensor. I used to own a 2003 silverado. Is there any place on my 5.7 liter to hook it up? Oh, BTW I ordered a spark checker from amazon.
Sorry. I have replaced the cap, ignition coil, wires. Left the old spark plugs in because I replaced them 3 months ago. I haven't checked the pcv valve. I will do it today. The problem is that it is an OBD1 computer, NOT OBD2. I'm not sure how to hook up my fuel pressure sensor. I used to own a 2003 silverado. Is there any place on my 5.7 liter to hook it up? Oh, BTW I ordered a spark checker from amazon.
Last edited: