Metra 95-300 Double din for 88-94 Install

[Geno Valdez]

There is a large plastic wire guide that runs right where you need to cut so you'll want to pull it away from the dash before hand. This is the guide after the rough cut.

You must be registered for see images attach

I ended up pulling the harness out of the guide and cut it flush with the right side dash cut. The loom with push down out of the way. I thought I had a picture but I can't find it.


This is the piece with the radio roughed in. I'm waiting on the paint/dye to dry right now. I will post finished pictures when I'm done.

You must be registered for see images attach

I don't care for how the Kenwood DDX 373BT fits the Metra kit. I tried the radio in a couple other kits I have have laying around for other cars and the fit sucked too. I'm going to say it's this particular radio.

What did you use to cut ?

 

[laidbackbigun]

I used a dremel tool and a pair of snips for the whole operation.

 

[ccreddell]

I used a utility knife and a hacksaw blade for mine. Its not that difficult.

 

[Knuckle Dragger]

What did you use to cut ?

Dremel for the dash and wire cutters/razor blade for the loom.