Corvette style regulator / filter question

[5.3_silverado]

That's the one I asked about in the post above. 3/8 is the outer diameter but the inner is 5/16, you used this as your feed or return line, or both ?

3/8 feed and 5/16 for the return.

 

[92yukon]

Ok guess I was just confused because I'm used to speaking in terms of inside diameter when it comes to fuel lines and there are measured in outside diameters.

 

[5.3_silverado]

Ok guess I was just confused because I'm used to speaking in terms of inside diameter when it comes to fuel lines and there are measured in outside diameters.

Out side on these fuel lines. Make sure to get the fittings. I used nylon cause I run nothing but e85 in my truck. Simple to use and create. And looks really clean.

 

[92yukon]

Hey will my stock feed line from my tank to current filter screw into the corvette filter ?

 

[5.3_silverado]

Hey will my stock feed line from my tank to current filter screw into the corvette filter ?

No the Corvette filter is push and lock style.

 

[92yukon]

Ok guess the only thing I need to know now is what fittings you used to connect to the return and feed at the sending unit

 

[5.3_silverado]

Ok guess the only thing I need to know now is what fittings you used to connect to the return and feed at the sending unit

This is the 3/8 line.

You must be registered for see images attach

 

[5.3_silverado]

Ok guess the only thing I need to know now is what fittings you used to connect to the return and feed at the sending unit

This is the return line.

You must be registered for see images attach

 

[92yukon]

Thanks for all the help !

 

[5.3_silverado]

Thanks for all the help !

Your welcome.